Search results for "central boiler thermopex, 3/4""

1. Water Temperature Sensor Kit
   

   Replacement water temperature sensor kit used for Classic/Pallet Burner models(w/ digital temp controller (p/n 2000155); Also used for Forge, CleanFire, & Classic Edge models(w/ integrated FireStar controller). Kit includes sensor and wire lead, mastic tape, and instructions.
2. Water-to-Water Heat Exchanger 33", 3/4" FIP Side Arm (Fittings Sold Separately)
   

   The Water-to-Water Heat Exchanger is a stainless steel water-to-water, domestic water heat exchanger with 3/4" FIP end and side ports. Install on existing water heater for thermal circulating heat transfer. Fittings Kit (p/n 2053) or Push-fit Fittings Kit (9263) are...
3. Switch, On/Off/On, 20Mm Round
   

   Central Boiler fan-forced convector. Quiet operation, integral filters and thermostat connections. 3/4" FPT fittings and on-off- thermostat switch. Output up to 26,000 Btu/hr. Color - taupe. 24-Volt Thermostat (p/n 588 or 8200008) is optional.
4. Manifolds, 1/2" PEX, 4 Loop Set, Stainless
   

   Commonly used for radiant floor heat systems. NOTE: To operate this unit, an line voltage thermostat (Part #1267) is required. Each kit contains: See-through body flow meters with adjustable flow rates Isolation ball valves with 1" NPT fitting Temperature gauge...
5. Thermostat, 150 Degree F Kit
   

   Replacement thermostat for thermostatic valve kits. Includes gasket and instructions. Note that for the 1-1/4" thermostatic valve, two thermostats are required.
6. Heat Exchanger Coil, (125K Btu) 90 deg Ftgs
   

   Water-to-air heat exchanger coil with straight (p/n 107) or 90-degree (p/n 704) 3/4" FPT outlets. Used in forced-air furnaces with plenum size from approximately 18" x 18" to 18" x 20". Dimensions: 17-3/4" x 20" x 4-1/8".
7. Rope Ring, 3/4''Med Density Braid, 8''Id
   

   Replacement rope ring for chimneys. See table below for applications. When ordering p/n 7674 or 7594, specify the length in feet.
8. Thermopex Termination Cap 25 mm
   

   Fits snuggly over each end to protect and seal the insulation from water. Includes band clamps.
9. Heat Exchanger Coil, (50K Btu)
   

   Water-to-air heat exchanger coil with 90 _ 3/4" female pipe thread (FPT) outlets. Dimensions: 12-3/4" x 14" x 4-1/8".
10. Door Damper Solenoid, Classic Models p/n 443 (See description for proper p/n)
    

    This solenoid operates the door damper on Classic model furnaces/boilers. Because damper control solenoids are not interchangeable, check measurement and application dates carefully. Solenoid (p/n 443) has a 1-3/8" center-to-center bracket hole (for models after June 2000, including all E-Classic...